Coffee cup sleeve template

This script will give you a printed template for a coffee cup holder sleeve. Just measure either around (circumference) or across (diameter) the cup at the points where you want the top and bottom of the label to go, and specify the height between those measurements. Then print out the PDF, cut around the shape and slot the tabbed end into the slot - done!

If you don't have a cup to hand, you can model the cup by measuring across the very top and the very bottom, and entering the complete height. The resulting sleeve will match the cup dimensions precisely.

Pro tip: add a couple of mm here and there for an easy but snug fit.

I measured the diameterscircumferences.

The top was: mm and the bottom was: mm

Height of band as measured flat to the cup wallVertical height of band or cup, measured perpendicular to the table : mm